Lindy Switch User Manual download pdf (Page 60)

 









Serial port conﬁguration

This page provides all access to settings concerned with the two serial ports

(modem and power control) that are situated at the rear of the LINDY KVM IP.

Modem port

PPP Server IP Address / PPP Client IP Address

When a user dials into the LINDY KVM IP via a modem or ISDN adapter, the

LINDY KVM IP sets up a temporary two-device network using PPP (Point to Point

Protocol). For this purpose, both devices must have ‘dummy’ IP addresses so that

they can communicate correctly. These two addresses can be almost anything

expressed in the quad octet format (i.e. 192.168.3.1.). However, it is advisable

not to make them the same as the real IP addresses used by either the remote

system or the LINDY KVM IP.

Baud Rate

This option determines the speed of the serial connection between the LINDY

KVM IP and a connected modem or ISDN terminal adapter. The default setting is

115200. The other communication settings are ﬁxed as: No parity, 8 bit word, 1

stop bit.

Initialization Sequence

The codes entered here are used to prepare the connected modem or ISDN

terminal adapter for use with the LINDY KVM IP. The default code is a Hayes-

compatible string to conﬁgure auto answer mode and would be understood by

the vast majority of modem/ISDN devices. The code is sent when the LINDY KVM

IP is ﬁrst switched on or whenever the Initialize button is clicked.

Initialize

When clicked, this option sends the characters entered in the Initialisation

sequence ﬁeld to the connected modem or ISDN terminal adapter.

Restore Defaults

When clicked, this option resets the Baud rate and Initialisation sequence values

to their original default settings.

Power control port

Baud Rate

This option conﬁgures the speed of the serial connection between the LINDY

KVM IP and a connected power control unit. The default setting is 9600 as used

by the majority of power units. The other communication settings are ﬁxed as:

No parity, 8 bit word, 1 stop bit.

To get here

1 Using VNC viewer or a browser, log on as the ‘admin’ user.

2 Click the ‘Conﬁgure’ button in the top right corner.

3 Click the ‘Serial Port Conﬁguration’ option.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 75 76

Comments to this Manuals

No comments

Lindy Switch User Manual Page 60

Comments to this Manuals

Related products and manuals for Computer Accessories Lindy Switch