© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (November 2004) SATA Raid+USB2.0 +1394a 9 port PCI Card User Manual
- 10 - 16. Select 'CD-ROM drive' and click 'Next', Select 'The Updated driver (Recommended)' NEC PCI To USB Enhanced
- 11 - Reboot the system if your Windows ME drive is connected on the SiI 3112 Controller. 4.8.Verifying The installation under Windows 98SE and M
- 12 - This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) this device may not cause harmf
- 2 - 1. Introduction This PCI Host Adapter is a PCI controller board which can upgrade your desktop computer to have dual independent Serial ATA
- 3 - Fully compliant with Serial ATA 1.0 specifications. Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and
- 4 - Disk Striping (RAID 0) Striping is a performance-oriented, non-redundant data mapping technique. While Striping is discussed as a RAID Set typ
- 5 - 3.2. Creating Mirrored Sets (RAID 1) 1. As the BIOS boots, Press CTRL+S or F4 to enter the raid bios utility. 2. Select Create RAID set. Press
- 6 - to function properly, this old metadata must be first overwritten with the new metadata. To resolve this, select Resolve Conflicts, and the co
- 7 - 'Next'. 4. Under 'Optional search locations' insure that 'CD-ROM drives' is only checked. 5. Insert the CD Driv
- 8 - correctly. 1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware' tab, and then on
- 9 - 'System Properties ' , select 'Device Manager', right click on the '?PCI RAID controller' and select 'Prope
Comments to this Manuals