© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (November 2004) RAID SATA II – 3Gbps 4 Ports PCI-X Host User Manual E
- 10 - This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not c
- 2 - 1. Introduction This RAID SATA II –3Gbps 4Ports PCI-X Host Adapter is a PCI to 4Ports Serial ATA host controller board. It provides a 64bit,
- 3 - Four high speed Serial ATA interface ports, each supporting 1st generation & 2nd generation Serial ATA data rates 1.5Gbps/ 3Gbps. Prov
- 4 - data. This card provides two RAID Set types, Striped (RAID 0) and Mirrored (RAID 1). Disk Striping (RAID 0) Striping is a performance-orient
- 5 - 8. Your RAID configuration is complete. Please proceed to software installation section. 3.2. Creating Mirrored Sets (RAID 1) 1. As the BI
- 6 - 3.5. Resolving Conflict When a RAID set is created, the metadata written to the disk includes drive connection information (Primary and Seco
- 7 - required. 8. See instructions in section 4.4 to verify HBA was installed correctly. 4.2. Adding the HBA to an existing Windows NT Insta
- 8 - 8. The wizard will now copy the required files to the system and start the driver. After starting the driver the wizard will display a
- 9 - 4.6. Update new RAID driver on Windows 2000/XP with existing old driver 1. Right click on 'My Computer' and select 'Properties
Comments to this Manuals