Lindy 25036 User Manual download pdf

Modules for

24 + 2Giga N-WAY SNMP Ethernet Switch

Short Guide English

LINDY No. 25032 2 Port RJ-45 Gigabit 10/100/1000Base-T

LINDY No. 25033 1 Port Fibre Optic Gigabit Type SC 1000Base-SX

LINDY No. 25034 2 Port Fibre Optic Gigabit Type SC 1000Base-SX

LINDY No. 25035 1 Port Fibre Optic Fast Ethernet Type SC 100Base-FX

LINDY No. 25036 2 Port Fibre Optic Fast Ethernet Type SC 100Base-FX

Please find the complete detailed user manual in PDF format on

the CD-ROM enclosed with the 24+2Giga SNMP N-Way Switch.

Unpacking

The product should contain the following items:

o One module according to the LINDY part number, check from Part No. above.

o This Short Guide

Installation

Before you install the module in the 24+2Giga SNMP Switch, turn off the power to the switch.

Unscrew the face plate of the module slot, this is on the front of the 24+2Giga SNMP Switch.

Then install the module by fixing the two module screws. Switch on the power to 24+2Giga

SNMP switch again.

After the Switch is powered on, it will perform “self-diagnostic” (POSD). This process takes

about 1 min and 40 seconds to complete, during this process, the “DIAG” LED will blink green

and the Switch will not respond to any configuration program. All the connections to the Switch

will not be available at this time. When the process is completed, the “DIAG” LED will stay solid

green.

The following table describes the meaning of each LED indicator.

1 2

Page 2

Status LED Colour Solid Blinking Power Green Power is applied to this device N/A DIAG Green Self Diagnostic successful Performing self diagnostic

Related models: 25035 | 25033 | 25032 |

No comments