IIPPoowweerr CCoonnttrrooll 88 User Guide English LINDY No. 32416 www.lindy.com © LINDY ELECTRONICS LIMITED & LINDY-EL
1. CONNECTION Connect the IPower Control unit to the mains and to your Ethernet network. There are eight LEDs at the front of the unit which relate t
3. SWITCHING VIA ETHERNET Login to the website of the IPower Control, http:// “IP Address of IPower Control” (e.g. 192.168.0.2). You may need to ent
5. PORT CONFIGURATION The ports can be selected individually from the roll-up menu at the configuration site. The following settings can be modified
6. NETWORK CONFIGURATION The following settings can be modified in the configuration menu: Device Name A name with a maximum of 15 characters can be
7. OPERATING MODES The IPower Control can be started in two ways: Boot Mode To start the IPower Control in boot mode, the button at the front must b
10. DEFAULT SETTINGS In order to restore the default settings the IPower Control must be started in boot mode (see section 7). Launch IPCnet_conf.exe
12. FAQs Connection The IPower Control is connected to a network but... ...the LEDs do not illuminate Please check the connection to the elect
Comments to this Manuals