Lindy 21615 User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Dual Rail Console with Modular KVM Switch User’s Manual
16
3.3.2. Connecting the Console
To connect an LCD console to a computer, perform the following steps
1. Turn off your computer. You should always turn off your computer before connecting or
disconnecting a device.
2. Connect the video (VGA) connector of the KVM cable to the video card connector on the rear
panel of your computer.
3. Identify and connect the PS/2 mouse and PS/2 keyboard connector to the correct PS/2 ports
on the rear panel of your computer, or if you prefer you can use the USB interface to connect
your computer. Use PS/2-USB switch (highlighted above) to select your interface.
Please Note: Do not connect PS/2 and USB cables at the same time!
4. Connect the AC to DC power adapter to the power inlet on the console and then to a power
outlet.
3.4. Turning the Console On
Make sure that the AC to DC power adapter and all other cables are connected properly. Be sure
to tighten all connector screws. Using two hands, grasp the rear of the console, lift the tab and pull
the panel up and forward. This will disengage the momentary on / off switch and the unit should
power on. The LED on the left or under of the monitor panel should turn from orange to green,
verifying that the unit is operational.
3.5. Testing the Console
To test that the console is working properly, perform the following steps:
1. Power up the console, and then turn on your computer
2. If the unit does not power up when the panel is pulled up, try pushing the soft power
on/off button on the left or under side of the monitor panel to power up the unit.
3. Make sure the video image is centered within the screen area. Use the OSD controls to adjust
the image (see note below) or press the Auto button on the right hand side of the monitor.
Please Note: You can adjust the horizontal and vertical position, contrast, and brightness to
PS/2-USB switch
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments